Shirley DeArmas
Over the weekend I had the pleasure of working with two models on an independent photo shoot. With nearly every click of the shutter going toward university work or wedding events lately, I have had little time to work on shooting for my portfolio - and perhaps more importantly, just for fun.
Shirley DeArmas and Nikki Jagt were kind enough to trade half of their Saturday in exchange for some free images. I in turn gained two models and a collection of beautiful images. We opened the studio doors around 9 a.m. and we wrapped about 2 p.m. I hauled lighting gear and worked on the setup and calibration while the girls were in makeup, courtesy of the very talented Wendy Riley. The actual shoot went about 2-2.5 hours and the shot selection produced was incredible.
Nikki Jagt
For more than half of the shoot, I used a classic beauty lighting setup that provided smooth, elegant lighting. All of these shots were focused on the waist up. For the final third of the shoot I adjusted the lighting to a four light setup to cover more full body shots. The four light scenario may be discussed in a future post, but for now I'd like to focus on beauty lighting.
Beauty lighting is a general title assigned to shooting scenarios where the main purpose is to provide even illumination from top to bottom, and at times, from left to right. It can be used for a variety of subjects, but is typically used on females in 2/3 portrait or tighter. You'll see it in advertisements for makeup and skin cleansers as well in model portfolios. This can be achieved in numerous ways and different photographers favor different approaches. Some setups include a beauty dish over head with a fill card below the face, a ring light with diffuser and what is referred to as clam shell lighting - which is the setup discussed here.
Shirley DeArmas
Clam shell lighting consists of a pair of diffused light sources positioned above and below the model and tilted about 45 degrees toward the subject. The setup looks like an open clam shell, hence the name. The lights will obviously be in front of the model, and the tilt of the lights will cast overlapping light on the subject, providing a nice, smooth, even illumination. To further enhance the setup I added a pair of white reflectors, one on either side of the model, to kick some light back into the sides of the face and body.
Nikki Jagt
The diagram below shows the setup from the side. As you can see, the softboxes are positioned about 45 degrees above and below the model with the two reflectors on either side. Note that the closest reflector has a reduced opacity to allow for a more three dimensional look at the scenario. The setup works best if the upper light is placed on a boom because the images are actually shot throw the opening between the softboxes and the obstruction of a light stand will prove extremely frustrating. It is worth noting that this same setup can be achieved with off-camera strobe like your Nikon, Canon or other portable flashes. Keep in mind, it will be harder to parallel the power of the studio strobes, but you can certainly compensate for this by adjusting your exposure settings. These images were shot using a pair Alien Bees 800 lights in the foldable medium and large softboxes. The reflectors can be anything from poster board to foam core to collapsible reflectors. I used a pair of Photoflex light panels with the diffusion surfaces to bounce the light. The images were shot at ISO 50 at 1/250th at f/8. The lights were set to approximately one quarter output, but were adjusted using the Alien Bees LG4X wired remote control for the variation in skin tones and wardrobe color and materials.
A little retouching was done in Photoshop. The basics apply here. I removed the blemishes not concealed by the makeup, improved contrast a bit around the eyes and softened the skin. Ta-da! It's really the same thing you would do for any portrait retouching, with the exception (maybe) of the skin softening. It's really just a duplicated layer with 2-2.5 pixel Gaussian blur added. Then the layer opacity is reduced to 30-40 percent and then the important features - i.e. everything but the skin - are erased, revealing the original layer, and then the layers are flattened. Presto. You may use other methods for this, but I'm not a Photoshp expert. I just use what seems to work for me.
As you can see, the lighting is breathtaking, but having beautiful models certainly doesn't hurt. This is a relatively simple lighting setup and it can produce spectacular results. Combine this method with elegant subjects and a laid back, fun atmosphere and the results will certainly not disappoint.
Until next time, happy shooting.
- R
